fbpx

4 Common Reasons Your Toilet Won’t Flush

    GET IN TOUCH

    Our experts respond quickly to your request and are out to the property as soon as possible.

    Wondering why your toilet won’t flush? Looking at these four common reasons will give you an idea of what’s wrong, and what to do to fix your problem. The post 4 Common Reasons Your Toilet Won’t Flush appeared first on Twin Home Experts.

    toilet 1

    Here are the most common issues we have dealt with on toilet flushing problems:

    When I flush, water just rises, why?

    This means that you have a clog in the weir, trapway or outlet. If this happens, be very cautious. We have had our clients flush, walk away and flood their homes.

    Quickly turn that little valve off at the bottom of the toilet.

    Don’t have a plunger, but have a toilet bowl cleaner brush?

    Check this video out, where my Twin brother Dave shows you how to unclog a toilet without a plunger.

    Text a Twin at  818-402-8682  and say “toilet help”.

    There is not enough water in the tank

    This is a huge cause of toilet flushing problems. If the water level is low, then it creates a very weak flush and is not strong enough to flush away solids.

    How it creates a weak flush

    When you flush your toilet, you’re actually letting water from the tank into the bowl . Releasing a lot of water into the bowl from the tank quickly generates the suction required to flush the toilet.

    Twin toilet tip: Always hold the handle down when flushing for another 10 or 15 seconds

    When the tank doesn’t contain enough water, it doesn’t release as much water as it should when flushed.

    You’ll notice a weaker flush or water may enter your toilet bowl without starting a flush at all.

    How you can fix this…

    Most toilet manufacturers leave a mark inside the toilet tank to indicate how much water it should store.

    Remove the tank lid, find this mark inside the tank and make sure the water level rises to it after every flush.

    If you can’t find a manufacturer’s mark, make sure water rises to just below the tank’s overflow tube. If the water in your tank doesn’t rise to the mark, you have to adjust it .

    Different toilets use different components to set the tank’s water level.

    Most older toilets use either a float ball & rod of some kind.

    The new vertical type fill valve stops filling the tank with water when the water touches the bottom of the float. Depending on what you have, you can adjust the water level.

    oveflow

    My toilet tank won’t fill

    More than likely if your in this situation, you have debris between the shut-off valve and the bottom of the tank.

    Turn the water off, and disconnect the water flex hose from the tank. Grab a small bucket and flush out the debris. If that doesn’t work then it’s probably your fill valve.

    My toilet tank water is all the way to the top, and I don’t have a clog, but still very slow flush

    This issue, is more than likely caused by calcium deposits built up in the rim holes.

    You can restore the water flow by cleaning the Rim flush holes/ bowl ports.

    I’m so done with my toilet not flushing, I just want to buy another one. How do I choose a toilet to buy?

    Conclusion